Fiber & Telecom Locating in Texas

Sometimes, and it is the honest hard case in this trade. All-dielectric fiber contains no metal, so an electromagnetic locator has nothing to put a signal on and cannot trace the cable itself under any settings. The locate depends on something else being there: a tracer wire, a toneable duct with an integral conductor, corrugated steel armor that is bonded and grounded at both ends, or an accessible duct end where a conductive rodder or a sonde can be pushed through and tracked from the surface. Where none of that exists, ground penetrating radar can often image the duct as a reflection, though it degrades badly in wet clay and other high-conductivity soils and struggles to resolve a small-diameter duct at shallow depth. Tell the locating company up front whether the cable is dielectric, whether tracer wire was installed, and where the nearest handhole or vault sits, because it changes the equipment they bring and what they can honestly promise. If nothing produces a confident trace, the correct answer is to expose the duct by vacuum excavation rather than bore on an assumption.

Shallower than most people expect, and inconsistently so. Bored or plowed backbone commonly sits somewhere in the range of two to four feet with roadway and rail crossings deeper, but micro-trenched cable can be less than a foot below the pavement surface, and a residential or building drop is often plowed in a few inches down or left just under the sod. Recently installed plant is the most commonly struck, because it is new enough that nobody expects it and shallow enough that ordinary work reaches it. Horizontal position from a clean active trace is generally reliable and is marked as a tolerance zone rather than a single line, but depth is an estimate, and it is worse on shallow targets and on ducts sharing a bank with other elements. ASCE 38-22 classes surface geophysics as Quality Level B; only exposing the duct, normally by vacuum excavation, reaches Quality Level A. Hand dig or vacuum excavate inside the tolerance zone regardless of how clean the orange paint looks.

Private locating is quoted per job rather than off a published rate. What moves the number is how much ground has to be covered, how many utilities are in play, whether the lines are metallic or plastic, how reachable the meters, valves, and tracer wire access points are, and whether you need surface marks only or a drawing and GPS data as well. Across Texas the number also moves with travel distance and local ground conditions, so companies quote the specific job. Describe it once through Utility Hotline and locating companies working that part of Texas send you their own quotes.

Only on the public side. Texas 811 (811) is free, is required by law before excavation in most jurisdictions, and notifies its member facility owners so they mark the lines they own, which generally means up to the meter or the right-of-way. Membership is not universal, so how much of a service lateral gets marked can vary from one system to the next. Nothing on the private side, meaning past the meter or the property line, is in scope anywhere in Texas, and that is the ground a private locating company covers. Place the ticket, book the private locate, and use both.

Coverage is settled one request at a time rather than off a published service-area map. Fiber & Telecom Locating requests arrive from cities across Texas, spanning the Southwest, and go to the companies working that particular ground, since fiber lines are routine work for a private locating company. Coverage runs deeper around the larger metros, and some crews travel for rural, agricultural, and multi-site work. Tell us the job site and we send your request to the companies covering it.